Agilent Technologies InfiniiVision 3000 X-Series - Trigger:shold:time:hold

936 Agilent InfiniiVision 3000 X-Series Oscilloscopes Programmer's Guide
31 :TRIGger Commands
:TRIGger:SHOLd:TIME:HOLD
(see page 1138)
Command Syntax
:TRIGger:SHOLd:TIME:HOLD <time>[suffix]
<time> ::= floating-point number in NR3 format
[suffix] ::= {s | ms | us | ns | ps}
The :TRIGger:SHOLd:TIME:HOLD command sets the hold time.
Query Syntax
:TRIGger:SHOLd:TIME:HOLD?
The :TRIGger:SHOLd:TIME:HOLD? query returns the currently specified
hold time.
Return Format
<time><NL>
<time> ::= floating-point number in NR3 format
See Also • "Introduction to :TRIGger Commands" on page 877