:POWer Commands 24
Agilent InfiniiVision 3000 X-Series Oscilloscopes Programmer's Guide 595
:POWer:TRANsient:NEXT
(see page 1138)
Command Syntax
:POWer:TRANsient:NEXT
The :POWer:TRANsient:NEXT command goes to the next step of the
transient analysis.
This command is equivalent to pressing the Next softkey on the
oscilloscope front panel when prompted during the analysis.
See Also • ":POWer:TRANsient:APPLy" on page 591
• ":POWer:TRANsient:EXIT" on page 592
• ":POWer:TRANsient:IINitial" on page 593
• ":POWer:TRANsient:INEW" on page 594
To Next Page
Loading...
