Agilent Technologies InfiniiVision 3000 X-Series

To Next Page

To Previous Page

678 Agilent InfiniiVision 3000 X-Series Oscilloscopes Programmer's Guide

27 :SBUS<n> Commands

:SBUS<n>:FLEXray:SOURce

(see page 1138)

Command Syntax

:SBUS<n>:FLEXray:SOURce <source>

<source> ::= {CHANnel<n>}

<n>::={1|2|3|4}

The :SBUS<n>:FLEXray:SOURce command specifies the input source for

the FlexRay signal.

Query Syntax

:SBUS<n>:FLEXray:SOURce?

The :SBUS<n>:FLEXray:SOURce? query returns the current source for the

FlexRay signal.

Return Format

See Also • "Introduction to :TRIGger Commands" on page 877

• ":SBUS<n>:FLEXray:TRIGger" on page 679

• ":SBUS<n>:FLEXray:TRIGger:EVENt:TYPE" on page 683

• ":SBUS<n>:FLEXray:AUTosetup" on page 671

Other manuals for Agilent Technologies InfiniiVision 3000 X-Series