732 Agilent InfiniiVision 3000 X-Series Oscilloscopes Programmer's Guide
27 :SBUS<n> Commands
:SBUS<n>:M1553:AUTosetup
(see page 1138)
Command Syntax
:SBUS<n>:M1553:TRIGger:AUTosetup
The :SBUS<n>:M1553:AUTosetup command automatically sets these options
for decoding and triggering on MIL- STD- 1553 signals:
• High/Low Trigger Thresholds: to a voltage value equal to ±1/3 division
based on the source channel's current V/div setting.
• Noise Reject: Off.
• Probe Attenuation: 10.0.
• Serial Decode: On.
• Trigger: the specified serial bus (n of SBUS<n>).
See Also • "Introduction to :TRIGger Commands" on page 877
• ":TRIGger:MODE" on page 886
• ":SBUS<n>:M1553:SOURce" on page 734
To Next Page
Loading...
