Agilent Technologies InfiniiVision 3000 X-Series - Save:power[:Start]

618 Agilent InfiniiVision 3000 X-Series Oscilloscopes Programmer's Guide
26 :SAVE Commands
:SAVE:POWer[:STARt]
(see page 1138)
Command Syntax
:SAVE:POWer[:STARt] [<file_name>]
<file_name> ::= quoted ASCII string
The :SAVE:POWer[:STARt] command saves the power measurement
application's current harmonics analysis results to a file.
See Also • "Introduction to :SAVE Commands" on page 607
• ":SAVE:FILename" on page 609
• Chapter 24, “:POWer Commands,” starting on page 529
NOTE
If a file extension is provided as part of a specified <file_name>, it must be ".csv".