Agilent Technologies InfiniiVision 3000 X-Series

734 Agilent InfiniiVision 3000 X-Series Oscilloscopes Programmer's Guide
27 :SBUS<n> Commands
:SBUS<n>:M1553:SOURce
(see page 1138)
Command Syntax
:SBUS<n>:M1553:SOURce <source>
<source> ::= {CHANnel<n>}
<n> ::= 1 to (# analog channels) in NR1 format
The :SBUS<n>:M1553:SOURce command sets the source of the
MIL- STD 1553 signal.
Use the :TRIGger:LEVel:HIGH and :TRIGger:LEVel:LOW commands to set
the thresold levels for the selected source.
Query Syntax
:SBUS<n>:M1553:TRIGger:SOURce?
The :SBUS<n>:M1553:SOURce? query returns the currently set source of
the MIL-STD 1553 signal.
Return Format
<source><NL>
<source> ::= {CHAN<n>}
<n> ::= 1 to (# analog channels) in NR1 format
See Also • ":TRIGger:LEVel:HIGH" on page 884
• ":TRIGger:LEVel:LOW" on page 885
• ":TRIGger:MODE" on page 886
• "Introduction to :TRIGger Commands" on page 877