Agilent Technologies InfiniiVision 3000 X-Series

To Next Page

To Previous Page

:TRIGger Commands 31

Agilent InfiniiVision 3000 X-Series Oscilloscopes Programmer's Guide 893

:TRIGger:DELay:TRIGger:COUNt

(see page 1138)

Command Syntax

:TRIGger:DELay:TRIGger:COUNt <count>

<count> ::= integer in NR1 format

The :TRIGger:DELay:TRIGger:COUNt command sets the Nth edge of the

trigger source to trigger on.

Query Syntax

:TRIGger:DELay:TRIGger:COUNt?

The :TRIGger:DELay:TRIGger:COUNt? query returns the current Nth trigger

edge setting.

Return Format

<count> ::= integer in NR1 format

See Also • "Introduction to :TRIGger Commands" on page 877

• ":TRIGger:DELay:TRIGger:SLOPe" on page 894

• ":TRIGger:DELay:TRIGger:SOURce" on page 895

• ":TRIGger:DELay:TDELay:TIME" on page 892

Other manuals for Agilent Technologies InfiniiVision 3000 X-Series