Agilent Technologies InfiniiVision 3000 X-Series

1086 Agilent InfiniiVision 3000 X-Series Oscilloscopes Programmer's Guide
35 Obsolete and Discontinued Commands
:MTESt:{STARt | STOP}
(see page 1138)
Command Syntax
:MTESt:{STARt | STOP}
The :MTESt:{STARt | STOP} command starts or stops the acquisition
system.
See Also • "Introduction to :MTESt Commands" on page 491
NOTE
The :MTESt:STARt and :MTESt:STOP commands are obsolete and are provided for
backward compatibility to previous oscilloscopes. Use the :RUN command (see page 219)
and :STOP command (see page 223) instead.