Agilent Technologies InfiniiVision 3000 X-Series Programmer's Guide

266 Agilent InfiniiVision 3000 X-Series Oscilloscopes Programmer's Guide
10 :CHANnel<n> Commands
:CHANnel<n>:DISPlay
(see page 1138)
Command Syntax
:CHANnel<n>:DISPlay <display value>
<display value> ::= {{1 | ON} | {0 | OFF}}
<n> ::= 1 to (# analog channels) in NR1 format
The :CHANnel<n>:DISPlay command turns the display of the specified
channel on or off.
Query Syntax
:CHANnel<n>:DISPlay?
The :CHANnel<n>:DISPlay? query returns the current display setting for
the specified channel.
Return Format
<display value><NL>
<display value> ::= {1 | 0}
See Also • "Introduction to :CHANnel<n> Commands" on page 262
• ":VIEW" on page 225
• ":BLANk" on page 198
• ":STATus" on page 222
• ":POD<n>:DISPlay" on page 525
• ":DIGital<d>:DISPlay" on page 291

Agilent Technologies InfiniiVision 3000 X-Series Specifications

General

Brand	Agilent Technologies
Model	InfiniiVision 3000 X-Series
Category	Test Equipment
Language	English