Agilent Technologies InfiniiVision 3000 X-Series

686 Agilent InfiniiVision 3000 X-Series Oscilloscopes Programmer's Guide
27 :SBUS<n> Commands
:SBUS<n>:FLEXray:TRIGger:FRAMe:ID
(see page 1138)
Command Syntax
:SBUS<n>:FLEXray:TRIGger:FRAMe:ID <frame_id>
<frame_id> ::= {ALL | <frame #>}
<frame #> ::= integer from 1-2047
The :SBUS<n>:FLEXray:TRIGger:FRAMe:ID command sets the FlexRay
frame ID to trigger on. The frame ID setting is only valid when the
FlexRay trigger mode is set to FRAMe.
Query Syntax
:SBUS<n>:FLEXray:TRIGger:FRAMe:ID?
The :SBUS<n>:FLEXray:TRIGger:FRAMe:ID? query returns the current
frame ID setting for the FlexRay frame trigger setup.
Return Format
<frame_id><NL>
<frame_id> ::= {ALL | <frame #>}
<frame #> ::= integer from 1-2047
See Also • "Introduction to :TRIGger Commands" on page 877
• ":TRIGger:MODE" on page 886
• ":SBUS<n>:FLEXray:TRIGger" on page 679