Agilent Technologies InfiniiVision 3000 X-Series

:TRIGger Commands 31
Agilent InfiniiVision 3000 X-Series Oscilloscopes Programmer's Guide 941
:TRIGger:TRANsition:SOURce
(see page 1138)
Command Syntax
:TRIGger:TRANsition:SOURce <source>
<source> ::= CHANnel<n>
<n> ::= 1 to (# analog channels) in NR1 format
The :TRIGger:TRANsition:SOURce command selects the channel used to
produce the trigger.
Query Syntax
:TRIGger:TRANsition:SOURce?
The :TRIGger:TRANsition:SOURce? query returns the current transition
trigger source.
Return Format
<source><NL>
<source> ::= CHAN<n>
See Also • "Introduction to :TRIGger Commands" on page 877
• ":TRIGger:MODE" on page 886
• ":TRIGger:TRANsition:SLOPe" on page 940