Agilent Technologies InfiniiVision 3000 X-Series

830 Agilent InfiniiVision 3000 X-Series Oscilloscopes Programmer's Guide
28 :SEARch Commands
:SEARch:SERial:IIC:PATTern:DATA
(see page 1138)
Command Syntax
:SEARch:SERial:IIC:PATTern:DATA <value>
<value> ::= integer or <string>
<string> ::= "0xnn" n ::= {0,..,9 | A,..,F}
The :SEARch:SERial:IIC:PATTern:DATA command specifies data values
when searching for IIC events.
To set don't care values, use the integer - 1.
When searching for IIC EEPROM data read events, you specify the data
value qualifier using the :SEARch:SERial:IIC:QUALifier command.
Query Syntax
:SEARch:SERial:IIC:PATTern:DATA?
The :SEARch:SERial:IIC:PATTern:DATA? query returns the current data
value setting.
Return Format
<value><NL>
<value> ::= integer
See Also • Chapter 28, “:SEARch Commands,” starting on page 777
• ":SEARch:SERial:IIC:MODE" on page 827
• ":SEARch:SERial:IIC:QUALifier" on page 832
• ":SEARch:SERial:IIC:PATTern:DATA2" on page 831