Agilent Technologies InfiniiVision 3000 X-Series

:TRIGger Commands 31
Agilent InfiniiVision 3000 X-Series Oscilloscopes Programmer's Guide 947
:TRIGger:TV:SOURce
(see page 1138)
Command Syntax
:TRIGger:TV:SOURce <source>
<source> ::= {CHANnel<n>}
<n> ::= 1 to (# analog channels) in NR1 format
The :TRIGger:TV:SOURce command selects the channel used to produce the
trigger.
Query Syntax
:TRIGger:TV:SOURce?
The :TRIGger:TV:SOURce? query returns the current TV trigger source.
Return Format
<source><NL>
<source> ::= {CHAN<n>}
See Also • "Introduction to :TRIGger Commands" on page 877
• ":TRIGger:MODE" on page 886
• ":TRIGger:TV:POLarity" on page 946
Example Code • "Example Code" on page 906