Agilent Technologies InfiniiVision 3000 X-Series

:SBUS<n> Commands 27
Agilent InfiniiVision 3000 X-Series Oscilloscopes Programmer's Guide 775
:SBUS<n>:UART:WIDTh
(see page 1138)
Command Syntax
:SBUS<n>:UART:WIDTh <width>
<width> ::= {5|6|7|8|9}
The :SBUS<n>:UART:WIDTh command determines the number of bits (5-9)
for each message "byte" for the serial decoder and/or trigger when in
UART mode.
Query Syntax
:SBUS<n>:UART:WIDTh?
The :SBUS<n>:UART:WIDTh? query returns the current UART width
setting.
Return Format
<width><NL>
<width> ::= {5|6|7|8|9}
See Also • "Introduction to :TRIGger Commands" on page 877
• ":TRIGger:MODE" on page 886
• ":SBUS<n>:UART:TRIGger:TYPE" on page 774