Agilent Technologies InfiniiVision 3000 X-Series

To Next Page

To Previous Page

1066 Agilent InfiniiVision 3000 X-Series Oscilloscopes Programmer's Guide

35 Obsolete and Discontinued Commands

:MEASure:LOWer

(see page 1138)

Command Syntax

:MEASure:LOWer <voltage>

The :MEASure:LOWer command sets the lower measurement threshold

value. This value and the UPPer value represent absolute values when the

thresholds are ABSolute and percentage when the thresholds are PERCent

as defined by the :MEASure:DEFine THResholds command.

Query Syntax

:MEASure:LOWer?

The :MEASure:LOWer? query returns the current lower threshold level.

Return Format

<voltage> ::= the user-defined lower threshold in volts in NR3 format

See Also • "Introduction to :MEASure Commands" on page 406

• ":MEASure:THResholds" on page 1069

• ":MEASure:UPPer" on page 1076

NOTE

The :MEASure:LOWer command is obsolete and is provided for backward compatibility to

previous oscilloscopes. Use the :MEASure:DEFine THResholds command (see page 413)

instead.

Other manuals for Agilent Technologies InfiniiVision 3000 X-Series