:POWer Commands 24
Agilent InfiniiVision 3000 X-Series Oscilloscopes Programmer's Guide 585
:POWer:SWITch:APPLy
(see page 1138)
Command Syntax
:POWer:SWITch:APPLy
The :POWer:SWITch:APPLy command applies the switching loss analysis
using the conduction calculation method, V reference, and I reference
settings.
See Also • ":POWer:SWITch:CONDuction" on page 586
• ":POWer:SWITch:IREFerence" on page 587
• ":POWer:SWITch:RDS" on page 588
• ":POWer:SWITch:VCE" on page 589
• ":POWer:SWITch:VREFerence" on page 590
• ":MEASure:ELOSs" on page 477
• ":MEASure:PLOSs" on page 484
To Next Page
Loading...
