:MARKer Commands 19
Agilent InfiniiVision 3000 X-Series Oscilloscopes Programmer's Guide 393
:MARKer:YUNits:USE
(see page 1138)
Command Syntax
:MARKer:YUNits:USE
When PERCent is selected for :MARKer:YUNits, the :MARKer:YUNits:USE
command sets the current Y1 location as 0 percent and the current Y2
location as 100 percent.
Once the 0 and 100 percent locations are set, inputs to and outputs from
the :MARKer:Y1Position, :MARKer:Y2Position, and :MARKer:YDELta
commands/queries are relative to the set locations.
See Also • "Introduction to :MARKer Commands" on page 380
• ":MARKer:YUNits" on page 392
• ":MARKer:X1Y1source" on page 383
• ":MARKer:X2Y2source" on page 385
• ":MEASure:SOURce" on page 444
• ":MARKer:Y1Position" on page 389
• ":MARKer:Y2Position" on page 390
• ":MARKer:YDELta" on page 391
To Next Page
Loading...
