:WAVeform Commands 32
Agilent InfiniiVision 3000 X-Series Oscilloscopes Programmer's Guide 993
:WAVeform:YORigin
(see page 1138)
Query Syntax
:WAVeform:YORigin?
The :WAVeform:YORigin? query returns the y- origin value for the currently
specified source. This value is the Y- axis value of the data value specified
by the :WAVeform:YREFerence value. For this product, this is the Y- axis
value of the center of the screen.
Return Format
<value><NL>
<value> ::= y-origin in the current preamble in 32-bit
floating point NR3 format
See Also • "Introduction to :WAVeform Commands" on page 961
• ":WAVeform:PREamble" on page 976
• ":WAVeform:YREFerence" on page 994
Example Code • "Example Code" on page 977
To Next Page
Loading...
