Agilent Technologies InfiniiVision 3000 X-Series

588 Agilent InfiniiVision 3000 X-Series Oscilloscopes Programmer's Guide
24 :POWer Commands
:POWer:SWITch:RDS
(see page 1138)
Command Syntax
:POWer:SWITch:RDS <value>[suffix]
<value> ::= Rds(on) value in NR3 format
[suffix] ::= {OHM | mOHM}
The :POWer:SWITch:RDS command specifies the Rds(on) value when the
RDS conduction calculation method is chosen (by
:POWer:SWITch:CONDuction).
Query Syntax
:POWer:SWITch:RDS?
The :POWer:SWITch:RDS query returns the Rds(on) value.
Return Format
<value><NL>
<value> ::= Rds(on) value in NR3 format
See Also • ":POWer:SWITch:APPLy" on page 585
• ":POWer:SWITch:CONDuction" on page 586
• ":POWer:SWITch:IREFerence" on page 587
• ":POWer:SWITch:VCE" on page 589
• ":POWer:SWITch:VREFerence" on page 590