Agilent Technologies InfiniiVision 3000 X-Series - Wgen:arbitrary:data:dac

:WGEN Commands 33
Agilent InfiniiVision 3000 X-Series Oscilloscopes Programmer's Guide 1003
:WGEN:ARBitrary:DATA:DAC
(see page 1138)
Command Syntax
:WGEN:ARBitrary:DATA:DAC {<binary> | <value>, <value> ...}
<binary> ::= decimal 16-bit integer values between -512 to +511
in IEEE 488.2 binary block format
<value> ::= decimal integer values between -512 to +511
in comma-separated NR1 format
The :WGEN:ARBitrary:DATA:DAC command downloads an arbitrary
waveform using 16- bit integer (DAC) values.
See Also • ":WGEN:ARBitrary:DATA" on page 1000
• ":SAVE:ARBitrary[:STARt]" on page 608
• ":RECall:ARBitrary[:STARt]" on page 599