Agilent Technologies InfiniiVision 3000 X-Series

:POWer Commands 24
Agilent InfiniiVision 3000 X-Series Oscilloscopes Programmer's Guide 559
:POWer:PSRR:FREQuency:MINimum
(see page 1138)
Command Syntax
:POWer:PSRR:FREQuency:MINimum <value>[suffix]
<value> ::= {1 | 10 | 100 | 1000 | 10000 | 100000 | 1000000 | 10000000}
[suffix] ::= {Hz | kHz| MHz}
The :POWer:PSRR:FREQuency:MINimum command sets the start sweep
frequency value. The measurement is displayed on a log scale, so you can
select from decade values.
Query Syntax
:POWer:PSRR:FREQuency:MINimum?
The :POWer:PSRR:FREQuency:MINimum query returns the minimum sweep
frequency setting.
Return Format
<value><NL>
<value> ::= {1 | 10 | 100 | 1000 | 10000 | 100000 | 1000000 | 10000000}
See Also • ":POWer:PSRR:APPLy" on page 557
• ":POWer:PSRR:FREQuency:MAXimum" on page 558
• ":POWer:PSRR:RMAXimum" on page 560