Agilent Technologies InfiniiVision 3000 X-Series

564 Agilent InfiniiVision 3000 X-Series Oscilloscopes Programmer's Guide
24 :POWer Commands
:POWer:SIGNals:AUTosetup
(see page 1138)
Command Syntax
:POWer:SIGNals:AUTosetup <analysis>
<analysis> ::= {HARMonics | EFFiciency | RIPPle | MODulation | QUALity
| SLEW | SWITch}
The :POWer:SIGNals:AUTosetup command performs automated oscilloscope
setup for the signals in the specified type of power analysis.
See Also • ":POWer:HARMonics:DISPlay" on page 539
• ":POWer:EFFiciency:APPLy" on page 535
• ":POWer:RIPPle:APPLy" on page 563
• ":POWer:MODulation:APPLy" on page 550
• ":POWer:QUALity:APPLy" on page 561
• ":POWer:SLEW:APPLy" on page 583
• ":POWer:SWITch:APPLy" on page 585
• ":POWer:SIGNals:CYCLes:HARMonics" on page 565
• ":POWer:SIGNals:CYCLes:QUALity" on page 566
• ":POWer:SIGNals:DURation:EFFiciency" on page 567
• ":POWer:SIGNals:DURation:MODulation" on page 568
• ":POWer:SIGNals:DURation:RIPPle" on page 571
• ":POWer:SIGNals:IEXPected" on page 573
• ":POWer:SIGNals:OVERshoot" on page 574
• ":POWer:SIGNals:SOURce:CURRent<i>" on page 581
• ":POWer:SIGNals:SOURce:VOLTage<i>" on page 582