Agilent Technologies InfiniiVision 3000 X-Series

1004 Agilent InfiniiVision 3000 X-Series Oscilloscopes Programmer's Guide
33 :WGEN Commands
:WGEN:ARBitrary:INTerpolate
(see page 1138)
Command Syntax
:WGEN:ARBitrary:INTerpolate {{0 | OFF} | {1 | ON}}
The :WGEN:ARBitrary:INTerpolate command enables or disables the
Interpolation control.
Interpolation specifies how lines are drawn between arbitrary waveform
points:
• When ON, lines are drawn between points in the arbitrary waveform.
Voltage levels change linearly between one point and the next.
• When OFF, all line segments in the arbitrary waveform are horizontal.
The voltage level of one point remains until the next point.
Query Syntax
:WGEN:ARBitrary:INTerpolate?
The :WGEN:ARBitrary:INTerpolate query returns the current interpolation
setting.
Return Format
{0 | 1}
See Also • ":WGEN:ARBitrary:DATA" on page 1000
• ":WGEN:ARBitrary:DATA:DAC" on page 1003
• ":SAVE:ARBitrary[:STARt]" on page 608
• ":RECall:ARBitrary[:STARt]" on page 599