Agilent Technologies InfiniiVision 3000 X-Series - Sbus<N>:Lin:trigger:pattern:format

730 Agilent InfiniiVision 3000 X-Series Oscilloscopes Programmer's Guide
27 :SBUS<n> Commands
:SBUS<n>:LIN:TRIGger:PATTern:FORMat
(see page 1138)
Command Syntax
:SBUS<n>:LIN:TRIGger:PATTern:FORMat <base>
<base> ::= {BINary | HEX | DECimal}
The :SBUS<n>:LIN:TRIGger:PATTern:FORMat command sets the entry (and
query) number base used by the :SBUS<n>:LIN:TRIGger:PATTern:DATA
command. The default <base> is BINary.
Query Syntax
:SBUS<n>:LIN:TRIGger:PATTern:FORMat?
The :SBUS<n>:LIN:TRIGger:PATTern:FORMat? query returns the currently
set number base for LIN pattern data.
Return Format
<base><NL>
<base> ::= {BIN | HEX | DEC}
See Also • "Introduction to :TRIGger Commands" on page 877
• ":SBUS<n>:LIN:TRIGger:PATTern:DATA" on page 727
• ":SBUS<n>:LIN:TRIGger:PATTern:DATA:LENGth" on page 729