Agilent Technologies InfiniiVision 3000 X-Series

928 Agilent InfiniiVision 3000 X-Series Oscilloscopes Programmer's Guide
31 :TRIGger Commands
:TRIGger:RUNT:POLarity
(see page 1138)
Command Syntax
:TRIGger:RUNT:POLarity <polarity>
<polarity> ::= {POSitive | NEGative | EITHer}
The :TRIGger:RUNT:POLarity command sets the polarity for the runt
trigger:
• POSitive — positive runt pulses.
• NEGative — negative runt pulses.
• EITHer — either positive or negative runt pulses.
Query Syntax
:TRIGger:RUNT:POLarity?
The :TRIGger:RUNT:POLarity? query returns the runt trigger polarity.
Return Format
<polarity><NL>
<polarity> ::= {POS | NEG | EITH}
See Also • "Introduction to :TRIGger Commands" on page 877
• ":TRIGger:MODE" on page 886
• ":TRIGger:LEVel:HIGH" on page 884
• ":TRIGger:LEVel:LOW" on page 885
• ":TRIGger:RUNT:SOURce" on page 930