:SAVE Commands 26
Agilent InfiniiVision 3000 X-Series Oscilloscopes Programmer's Guide 615
:SAVE:LISTer[:STARt]
(see page 1138)
Command Syntax
:SAVE:LISTer[:STARt] [<file_name>]
<file_name> ::= quoted ASCII string
The :SAVE:LISTer[:STARt] command saves the Lister display data to a file.
See Also • "Introduction to :SAVE Commands" on page 607
• ":SAVE:FILename" on page 609
• Chapter 18, “:LISTer Commands,” starting on page 375
If a file extension is provided as part of a specified <file_name>, it must be ".csv".
To Next Page
Loading...
