Agilent Technologies InfiniiVision 3000 X-Series

552 Agilent InfiniiVision 3000 X-Series Oscilloscopes Programmer's Guide
24 :POWer Commands
:POWer:MODulation:TYPE
(see page 1138)
Command Syntax
:POWer:MODulation:TYPE <modulation>
<modulation> ::= {VAVerage | ACRMs | VRATio | PERiod | FREQuency
| PWIDith | NWIDth | DUTYcycle | RISetime | FALLtime}
The :POWer:MODulation:TYPE command selects the type of measurement
to make in the modulation analysis:
• VAVerage
• ACRMs
• VRATio
• PERiod
• FREQuency
• PWIDth (positive pulse width)
• NWIDth (negative pulse width)
• DUTYcycle
• RISetime
• FALLtime
Query Syntax
:POWer:MODulation:TYPE?
The :POWer:MODulation:TYPE query returns the modulation type setting.
Return Format
<modulation><NL>
<modulation> ::= {VAV | ACRM | VRAT | PER | FREQ | PWID | NWID | DUTY
| RIS | FALL}
See Also • ":POWer:MODulation:SOURce" on page 551
• ":POWer:MODulation:APPLy" on page 550
• ":MEASure:VAVerage" on page 457
• ":MEASure:VRMS" on page 463
• ":MEASure:VRATio" on page 462
• ":MEASure:PERiod" on page 433
• ":MEASure:FREQuency" on page 426
• ":MEASure:PWIDth" on page 437
• ":MEASure:NWIDth" on page 429
• ":MEASure:DUTYcycle" on page 424
• ":MEASure:RISetime" on page 441
• ":MEASure:FALLtime" on page 425