Agilent Technologies InfiniiVision 3000 X-Series - Hardcopy:network:slot

:HARDcopy Commands 17
Agilent InfiniiVision 3000 X-Series Oscilloscopes Programmer's Guide 369
:HARDcopy:NETWork:SLOT
(see page 1138)
Command Syntax
:HARDcopy:NETWork:SLOT <slot>
<slot> ::= {NET0 | NET1}
The :HARDcopy:NETWork:SLOT command selects the network printer slot
used for the address and apply commands. There are two network printer
slots to choose from.
Query Syntax
:HARDcopy:NETWork:SLOT?
The :HARDcopy:NETWork:SLOT? query returns the currently selected
network printer slot.
Return Format
<slot><NL>
<slot> ::= {NET0 | NET1}
See Also • "Introduction to :HARDcopy Commands" on page 358
• ":HARDcopy:NETWork:APPLy" on page 366
• ":HARDcopy:NETWork:ADDRess" on page 365
• ":HARDcopy:NETWork:DOMain" on page 367
• ":HARDcopy:NETWork:USERname" on page 370
• ":HARDcopy:NETWork:PASSword" on page 368