Agilent Technologies InfiniiVision 3000 X-Series

:TRIGger Commands 31
Agilent InfiniiVision 3000 X-Series Oscilloscopes Programmer's Guide 939
:TRIGger:TRANsition:QUALifier
(see page 1138)
Command Syntax
:TRIGger:TRANsition:QUALifier <qualifier>
<qualifier> ::= {GREaterthan | LESSthan}
The :TRIGger:TRANsition:QUALifier command specifies whether you are
looking for rise/fall times greater than or less than a certain time value.
The time value is set using the :TRIGger:TRANsition:TIME command.
Query Syntax
:TRIGger:TRANsition:QUALifier?
The :TRIGger:TRANsition:QUALifier? query returns the current rise/fall
time trigger qualifier setting.
Return Format
<qualifier><NL>
<qualifier> ::= {GRE | LESS}
See Also • "Introduction to :TRIGger Commands" on page 877
• ":TRIGger:TRANsition:TIME" on page 942
• ":TRIGger:MODE" on page 886