Agilent Technologies InfiniiVision 3000 X-Series - Power:inrush:next

:POWer Commands 24
Agilent InfiniiVision 3000 X-Series Oscilloscopes Programmer's Guide 549
:POWer:INRush:NEXT
(see page 1138)
Command Syntax
:POWer:INRush:NEXT
The :POWer:INRush:NEXT command goes to the next step of the inrush
current analysis.
This command is equivalent to pressing the Next softkey on the
oscilloscope front panel when prompted during the analysis.
See Also • ":POWer:INRush:APPLy" on page 547
• ":POWer:INRush:EXIT" on page 548