684 Agilent InfiniiVision 3000 X-Series Oscilloscopes Programmer's Guide
27 :SBUS<n> Commands
:SBUS<n>:FLEXray:TRIGger:FRAMe:CCBase
(see page 1138)
Command Syntax
:SBUS<n>:FLEXray:TRIGger:FRAMe:CCBase <cycle_count_base>
<cycle_count_base> ::= integer from 0-63
The :SBUS<n>:FLEXray:TRIGger:FRAMe:CCBase command sets the base of
the FlexRay cycle count (in the frame header) to trigger on. The cycle
count base setting is only valid when the FlexRay trigger mode is set to
FRAME.
Query Syntax
:SBUS<n>:FLEXray:TRIGger:FRAMe:CCBase?
The :SBUS<n>:FLEXray:TRIGger:FRAMe:CCBase? query returns the current
cycle count base setting for the FlexRay frame trigger setup.
Return Format
<cycle_count_base><NL>
<cycle_count_base> ::= integer from 0-63
See Also • "Introduction to :TRIGger Commands" on page 877
• ":SBUS<n>:FLEXray:TRIGger" on page 679
To Next Page
Loading...
