592 Agilent InfiniiVision 3000 X-Series Oscilloscopes Programmer's Guide
24 :POWer Commands
:POWer:TRANsient:EXIT
(see page 1138)
Command Syntax
:POWer:TRANsient:EXIT
The :POWer:TRANsient:EXIT command exits (stops) the transient analysis.
This command is equivalent to pressing the Exit softkey on the oscilloscope
front panel during the analysis.
See Also • ":POWer:TRANsient:APPLy" on page 591
• ":POWer:TRANsient:IINitial" on page 593
• ":POWer:TRANsient:INEW" on page 594
• ":POWer:TRANsient:NEXT" on page 595
To Next Page
Loading...
