554 Agilent InfiniiVision 3000 X-Series Oscilloscopes Programmer's Guide
24 :POWer Commands
:POWer:ONOFf:EXIT
(see page 1138)
Command Syntax
:POWer:ONOFf:EXIT
The :POWer:ONOFf:EXIT command exits (stops) the turn on time/turn off
time analysis.
This command is equivalent to pressing the Exit softkey on the oscilloscope
front panel during the analysis.
See Also • ":POWer:ONOFf:APPLy" on page 553
• ":POWer:ONOFf:NEXT" on page 555
• ":POWer:ONOFf:TEST" on page 556
To Next Page
Loading...
