Agilent Technologies InfiniiVision 3000 X-Series

710 Agilent InfiniiVision 3000 X-Series Oscilloscopes Programmer's Guide
27 :SBUS<n> Commands
:SBUS<n>:IIC[:SOURce]:DATA
(see page 1138)
Command Syntax
:SBUS<n>:IIC:[SOURce:]DATA <source>
<source> ::= {CHANnel<n> | EXTernal} for the DSO models
<source> ::= {CHANnel<n> | DIGital<d>} for the MSO models
<n> ::= 1 to (# analog channels) in NR1 format
<d> ::= 0 to (# digital channels - 1) in NR1 format
The :SBUS<n>:IIC:[SOURce:]DATA command sets the source for IIC serial
data (SDA).
Query Syntax
:SBUS<n>:IIC:[SOURce:]DATA?
The :SBUS<n>:IIC:[SOURce:]DATA? query returns the current source for
IIC serial data.
Return Format
<source><NL>
See Also • "Introduction to :TRIGger Commands" on page 877
• ":SBUS<n>:IIC[:SOURce]:CLOCk" on page 709