Agilent Technologies InfiniiVision 3000 X-Series - Search:serial:lin:pattern:data

836 Agilent InfiniiVision 3000 X-Series Oscilloscopes Programmer's Guide
28 :SEARch Commands
:SEARch:SERial:LIN:PATTern:DATA
(see page 1138)
Command Syntax
:SEARch:SERial:LIN:PATTern:DATA <string>
When :SEARch:SERial:LIN:PATTern:FORMat DECimal,
<string> ::= "n" where n ::= 32-bit integer in unsigned decimal
When :SEARch:SERial:LIN:PATTern:FORMat HEX,
<string> ::= "0xnn...n" where n ::= {0,..,9 | A,..,F | X }
The :SEARch:SERial:LIN:PATTern:DATA command specifies the data value
when searching for LIN events.
The number base of the value entered with this command is specified
using the :SEARch:SERial:LIN:PATTern:FORMat command. To set don't care
values with the DATA command, the FORMat must be HEX.
The length of the data value entered is specified using the
:SEARch:SERial:LIN:PATTern:DATA:LENGth command.
Query Syntax
:SEARch:SERial:LIN:PATTern:DATA?
The :SEARch:SERial:LIN:PATTern:DATA? query returns the current data
value setting.
Return Format
<string><NL>
When :SEARch:SERial:LIN:PATTern:FORMat DECimal,
<string> ::= "n" where n ::= 32-bit integer in unsigned decimal or
"$" if data has any don't cares
When :SEARch:SERial:LIN:PATTern:FORMat HEX,
<string> ::= "0xnn...n" where n ::= {0,..,9 | A,..,F | X }
See Also • Chapter 28, “:SEARch Commands,” starting on page 777
• ":SEARch:SERial:LIN:MODE" on page 835
• ":SEARch:SERial:LIN:PATTern:FORMat" on page 838
• ":SEARch:SERial:LIN:PATTern:DATA:LENGth" on page 837