Agilent Technologies InfiniiVision 3000 X-Series Programmer's Guide

1146 Agilent InfiniiVision 3000 X-Series Oscilloscopes Programmer's Guide
39 More About Oscilloscope Commands
All Oscilloscope Commands Are Sequential
IEEE 488.2 makes the distinction between sequential and overlapped
commands:
• Sequential commands finish their task before the execution of the next
command starts.
• Overlapped commands run concurrently. Commands following an
overlapped command may be started before the overlapped command is
completed.
All of the oscilloscope commands are sequential.

Agilent Technologies InfiniiVision 3000 X-Series Specifications

General

Brand	Agilent Technologies
Model	InfiniiVision 3000 X-Series
Category	Test Equipment
Language	English