Agilent Technologies InfiniiVision 3000 X-Series

:TRIGger Commands 31
Agilent InfiniiVision 3000 X-Series Oscilloscopes Programmer's Guide 915
:TRIGger:GLITch:SOURce
(see page 1138)
Command Syntax
:TRIGger:GLITch:SOURce <source>
<source> ::= {DIGital<d> | CHANnel<n>}
<n> ::= 1 to (# analog channels) in NR1 format
<d> ::= 0 to (# digital channels - 1) in NR1 format
The :TRIGger:GLITch:SOURce command selects the channel that produces
the pulse width trigger.
Query Syntax
:TRIGger:GLITch:SOURce?
The :TRIGger:GLITch:SOURce? query returns the current pulse width
source. If all channels are off, the query returns "NONE".
Return Format
<source><NL>
See Also • "Introduction to :TRIGger Commands" on page 877
• ":TRIGger:MODE" on page 886
• ":TRIGger:GLITch:LEVel" on page 911
• ":TRIGger:GLITch:POLarity" on page 912
• ":TRIGger:GLITch:QUALifier" on page 913
• ":TRIGger:GLITch:RANGe" on page 914
Example Code • "Example Code" on page 906