To Next Page

To Previous Page

:MARKer Commands 19

Agilent InfiniiVision 3000 X-Series Oscilloscopes Programmer's Guide 381

:MARKer:MODE

(see page 1138)

Command Syntax

:MARKer:MODE <mode>

<mode> ::= {OFF | MEASurement | MANual | WAVeform}

The :MARKer:MODE command sets the cursors mode:

• OFF — removes the cursor information from the display.

• MANual — enables manual placement of the X and Y cursors.

If the front- panel cursors are off, or are set to the front- panel Hex or

Binary mode, setting :MARKer:MODE MANual will put the cursors in

the front-panel Normal mode.

• MEASurement — cursors track the most recent measurement.

Setting the mode to MEASurement sets the marker sources

(:MARKer:X1Y1source and :MARKer:X2Y2source) to the measurement

source (:MEASure:SOURce). Setting the measurement source remotely

always sets the marker sources.

• WAVeform — the Y1 cursor tracks the voltage value at the X1 cursor of

the waveform specified by the X1Y1source, and the Y2 cursor does the

same for the X2 cursor and its X2Y2source.

Query Syntax

:MARKer:MODE?

The :MARKer:MODE? query returns the current cursors mode.

Return Format

<mode> ::= {OFF | MEAS | MAN | WAV}

See Also • "Introduction to :MARKer Commands" on page 380

• ":MARKer:X1Y1source" on page 383

• ":MARKer:X2Y2source" on page 385

• ":MEASure:SOURce" on page 444

• ":MARKer:X1Position" on page 382

• ":MARKer:X2Position" on page 384

• ":MARKer:Y1Position" on page 389

• ":MARKer:Y2Position" on page 390

Agilent Technologies InfiniiVision 3000 X-Series Programmer's Guide

Other manuals for Agilent Technologies InfiniiVision 3000 X-Series