Agilent Technologies InfiniiVision 3000 X-Series

:SBUS<n> Commands 27
Agilent InfiniiVision 3000 X-Series Oscilloscopes Programmer's Guide 687
:SBUS<n>:FLEXray:TRIGger:FRAMe:TYPE
(see page 1138)
Command Syntax
:SBUS<n>:FLEXray:TRIGger:FRAMe:TYPE <frame_type>
<frame_type> ::= {NORMal | STARtup | NULL | SYNC | NSTArtup | NNULl |
NSYNc | ALL}
The :SBUS<n>:FLEXray:TRIGger:FRAMe:TYPE command sets the FlexRay
frame type to trigger on. The frame type setting is only valid when the
FlexRay trigger mode is set to FRAME.
• NORMal — will trigger on only normal (NSTArtup & NNULl & NSYNc)
frames.
• STARtup — will trigger on only startup frames.
• NULL — will trigger on only null frames.
• SYNC — will trigger on only sync frames.
• NSTArtup — will trigger on frames other than startup frames.
• NNULl — will trigger on frames other than null frames.
• NSYNc — will trigger on frames other than sync frames.
• ALL — will trigger on all FlexRay frame types.
Query Syntax
:SBUS<n>:FLEXray:TRIGger:FRAMe:TYPE?
The :SBUS<n>:FLEXray:TRIGger:FRAMe:TYPE? query returns the current
frame type setting for the FlexRay frame trigger setup.
Return Format
<frame_type><NL>
<frame_type> ::= {NORM | STAR | NULL | SYNC | NSTA | NNUL |
NSYN | ALL}
See Also • "Introduction to :TRIGger Commands" on page 877
• ":TRIGger:MODE" on page 886
• ":SBUS<n>:FLEXray:TRIGger" on page 679