Agilent Technologies InfiniiVision 3000 X-Series - Save:image:factors

:SAVE Commands 26
Agilent InfiniiVision 3000 X-Series Oscilloscopes Programmer's Guide 611
:SAVE:IMAGe:FACTors
(see page 1138)
Command Syntax
:SAVE:IMAGe:FACTors <factors>
<factors> ::= {{OFF | 0} | {ON | 1}}
The :SAVE:IMAGe:FACTors command controls whether the oscilloscope
factors are output along with the image.
Query Syntax
:SAVE:IMAGe:FACTors?
The :SAVE:IMAGe:FACTors? query returns a flag indicating whether
oscilloscope factors are output along with the image.
Return Format
<factors><NL>
<factors> ::= {0 | 1}
See Also • "Introduction to :SAVE Commands" on page 607
• ":SAVE:IMAGe[:STARt]" on page 610
• ":SAVE:IMAGe:FORMat" on page 612
• ":SAVE:IMAGe:INKSaver" on page 613
• ":SAVE:IMAGe:PALette" on page 614
NOTE
Factors are written to a separate file with the same path and base name but with the ".txt"
extension.