Agilent Technologies InfiniiVision 3000 X-Series Programmer's Guide

:FUNCtion Commands 16
Agilent InfiniiVision 3000 X-Series Oscilloscopes Programmer's Guide 343
:FUNCtion:INTegrate:IOFFset
(see page 1138)
Command Syntax
:FUNCtion:INTegrate:IOFFset <input_offset>
<input_offset> ::= DC offset correction in NR3 format.
The :FUNCtion:INTegrate:IOFFset command lets you enter a DC offset
correction factor for the integrate math waveform input signal. This DC
offset correction lets you level a "ramp"ed waveform.
Query Syntax
:FUNCtion:INTegrate:IOFFset?
The :FUNCtion:INTegrate:IOFFset? query returns the current input offset
value.
Return Format
<input_offset><NL>
<input_offset> ::= DC offset correction in NR3 format.
See Also • "Introduction to :FUNCtion Commands" on page 326
• ":FUNCtion:OPERation" on page 347

Agilent Technologies InfiniiVision 3000 X-Series Specifications

General

Brand	Agilent Technologies
Model	InfiniiVision 3000 X-Series
Category	Test Equipment
Language	English