Agilent Technologies InfiniiVision 3000 X-Series

42 Agilent InfiniiVision 3000 X-Series Oscilloscopes Programmer's Guide
1 What's New
Changed
Commands
:TRIGger:DELay:ARM:SLOPe (see page 890) Specifies the arming edge slope for the Edge
Then Edge trigger.
:TRIGger:DELay:ARM:SOURce (see page 891) Specifies the arming edge source for the Edge
Then Edge trigger.
:TRIGger:DELay:TDELay:TIME (see page 892) Specifies the delay time for the Edge Then Edge
trigger.
:TRIGger:DELay:TRIGger:COUNt (see page 893) Specifies the trigger edge count for the Edge
Then Edge trigger.
:TRIGger:DELay:TRIGger:SLOPe (see page 894) Specifies the trigger edge slope for the Edge
Then Edge trigger.
:TRIGger:DELay:TRIGger:SOURce (see
page 895)
Specifies the trigger edge source for the Edge
Then Edge trigger.
:TRIGger:FORCe (see page 880) Now documented, this command is equivalent
to the front panel [Force Trigger] key which
causes an acquisition to be captured even
though the trigger condition has not been met.
:TRIGger:OR (see page 917) Specifies edges for the OR'ed edge trigger.
Command Description
Command Differences
:DEMO:FUNCtion (see page 282) The ETE (Edge then Edge) function has been
added.
:TRIGger:MODE (see page 886) The OR and DELay modes are added for the
OR'ed edge trigger and the Edge Then Edge
trigger.
:WGEN:FUNCtion (see page 1007) The SINC, EXPRise, EXPFall, CARDiac, and
GAUSsian waveform types can now be
selected.