Agilent Technologies InfiniiVision 3000 X-Series Programmer's Guide

196 Agilent InfiniiVision 3000 X-Series Oscilloscopes Programmer's Guide
6 Root (:) Commands
:AUToscale:CHANnels
(see page 1138)
Command Syntax
:AUToscale:CHANnels <value>
<value> ::= {ALL | DISPlayed}
The :AUTOscale:CHANnels command specifies which channels will be
displayed on subsequent :AUToscales.
• When ALL is selected, all channels that meet the requirements of
:AUToscale will be displayed.
• When DISPlayed is selected, only the channels that are turned on are
autoscaled.
Use the :VIEW or :BLANk root commands to turn channels on or off.
Query Syntax
:AUToscale:CHANnels?
The :AUToscale:CHANnels? query returns the autoscale channels setting.
Return Format
<value><NL>
<value> ::= {ALL | DISP}
See Also • "Introduction to Root (:) Commands" on page 190
• ":AUToscale" on page 193
• ":AUToscale:AMODE" on page 195
• ":VIEW" on page 225
• ":BLANk" on page 198

Agilent Technologies InfiniiVision 3000 X-Series Specifications

General

Brand	Agilent Technologies
Model	InfiniiVision 3000 X-Series
Category	Test Equipment
Language	English