206 Agilent InfiniiVision 3000 X-Series Oscilloscopes Programmer's Guide
6 Root (:) Commands
Query Syntax :OPEE?
The :OPEE? query returns the current value contained in the Operation
Status Enable register as an integer number.
Return Format
<value><NL>
<value> ::= integer in NR1 format.
See Also • "Introduction to Root (:) Commands" on page 190
• ":AER (Arm Event Register)" on page 192
• ":CHANnel<n>:PROTection" on page 276
• ":OPERegister[:EVENt] (Operation Status Event Register)" on page 209
• ":OVLenable (Overload Event Enable Register)" on page 211
• ":OVLRegister (Overload Event Register)" on page 213
• "*STB (Read Status Byte)" on page 182
• "*SRE (Service Request Enable)" on page 180
To Next Page
Loading...
