Agilent Technologies InfiniiVision 3000 X-Series - Page 287

:DEMO Commands 11
Agilent InfiniiVision 3000 X-Series Oscilloscopes Programmer's Guide 287
:DEMO:OUTPut
(see page 1138)
Command Syntax
:DEMO:OUTPut <on_off>
<on_off> ::= {{1 | ON} | {0 | OFF}
The :DEMO:OUTPut command specifies whether the demo signal output is
ON (1) or OFF (0).
Query Syntax
:DEMO:OUTPut?
The :DEMO:OUTPut? query returns the current state of the demo signal
output setting.
Return Format
<on_off><NL>
<on_off> ::= {1 | 0}
See Also • "Introduction to :DEMO Commands" on page 281
• ":DEMO:FUNCtion" on page 282