998 Agilent InfiniiVision 3000 X-Series Oscilloscopes Programmer's Guide
33 :WGEN Commands
Introduction to
:WGEN
Commands
The :WGEN subsystem provides commands to select the waveform
generator function and parameters.
Reporting the Setup
Use :WGEN? to query setup information for the WGEN subsystem.
Return Format
The following is a sample response from the :WGEN? query. In this case,
the query was issued following the *RST command.
:WGEN:FUNC SIN;OUTP 0;FREQ +1.0000E+03;VOLT +500.0E-03;VOLT:OFFS
+0.0E+00;:WGEN:OUTP:LOAD ONEM
To Next Page
Loading...
