Epson AcuLaser CX11 - Page 379

EPSON AcuLaser CX11/CX11F Revision B
DISASSEMBLY AND ASSEMBLY Printer 381
REINSTALLATION
1. Attach the SENSOR ASSY ADC to the HOLDER-ADC 2ND matching the
boss on the SENSOR ASSY ADC with the hole on the HOLDER-ADC 2ND.
2. Secure the SENSOR ASSY ADC to the HOLDER-ADC 2ND with the two
screws (silver, with washer, tapping, 8 mm).
3. Route the harness on the HOLDER-ADC 2ND as shown in Figure 4-67, and
attach the HOLDER-ADC 2ND to the main unit together with the SENSOR
ASSY ADC matching the protrusion of the HOLDER-ADC 2ND with the hole
on the main unit.
4. Secure the HOLDER-ADC 2ND to the main unit with the two screws (silver, with
flange, 8 mm).
5. Connect P/J431 to the SENSOR ASSY ADC.
6. Attach FUSER ASSY. (p415)
7. Fasten both the left and right sides of FRAME ASSY-2ND to the main unit with
SPRING-2ND. (p371)
8. Attach CAM ASSY-2ND. (p376)
9. Attach SENSOR 2BTR RETRACT. (p382)
10. Attach PLATE BIAS-2ND. (p384)
11. Attach 2ND BTR ASSY. (p374)
12. Attach CHUTE ASSY-FSR and COVER ASSY-RR 2ND. (p366)
13. Attach COVER FUSER. (p311)
14. Attach COVER ASSY RH. (p326)