EPSON AcuLaser CX11/CX11F Revision B
APPENDIX Fax Unit System 647
LIN_REDIAL_TIMES 310 001
{
083
Number of redialing
When the product cannot send a fax by auto dialing because the
receiving fax machine does not answer or is busy, it performs
redialing set number of times.
0 to 255 times (1 step = 1 time)
0 = Does not redial
5 times
(5)
---
LIN_REDIAL_INTERVAL 310 002
---
084 Redialing intervals
1 to 255 min (1 step = 1 min) 1 minute
(1)
---
LIN_RING_RESPONSE_TIME 310 004
{
085
Attached phone ringing time-out period
When the phone rings with the reception mode set to “auto switch”,
the product starts to receive a fax after a lapse of the set time period.
1 to 99 sec (1 step = 1 sec) 10 seconds
(10)
---
LIN_RESEND_TIMES 310 025
---
086
Number of refaxing
When an automatic fax sending is interrupted due to line fault or any
other external factors, the product starts to send remaining pages
after a lapse of a predetermined time interval. The attempt is made
the set number of times.
0 to 5 times (1 step = 1 time) 3 times
(3)
---
LIN_COMM_INTERVAL 310 026
---
087
Time interval between the independent communications 3 to 255 sec (1 step = 1 sec) 8 sec
(8)
---
LIN_NUM_CHECK_ENABLE 310 027
---
088
Enables or disables calling control for identical destination 0 = Disable
1 = Enable
Enable
(1)
---
LIN_NUM_CHECK_INTERVAL 310 028
---
089
Calling control time for identical destination 1 to 255 sec (1 step = 1 sec) 60 seconds
(60)
---
LIN_CNG_DETECT_TIME 310 030
---
08A
CNG signal (dial tone) detecting time
Use this setting when phone-first mode is set.
If CNG signal is not detected during the set time interval, the
product starts to call the answer phone (attached phone).
0 to 25.5 sec (1 step = 100 ms) 5.5 seconds
(55)
Not used
LIN_REDIAL_TIMES_MAX 310 078
---
08B
Maximum number of redialing 0 to 255 times (1 step = 1 time) 99 times
(99)
---
LIN_RING_TIMES_MIN 310 079
---
08C
Minimum time interval between answering and starting to receive a
fax
0 to 10 sec (1 step = 1 sec) 0 second
(0)
---
Table 7-18. List of System Parameter (Phone Line)
Label
Maintenance
Code
User
Access
Internal
Address
Description Setting Value Default Remarks
Main Sub