Epson AcuLaser CX11 - Page 649

EPSON AcuLaser CX11/CX11F Revision B
APPENDIX Fax Unit System 651
COM_V34_SYM_RATE_THRESH2 310 014
---
0AB
Symbol speed threshold value 2
Minimum S/N permissible level
The smaller value, the easier it is to select higher symbol speed.
0xFA = -6 dB Easy to judge
0xFB = -5 dB
0xFC = -4 dB
0xFD = -3 dB
↑
0xFE = -2 dB
0xFF = -1 dB
0x00 = 0 dB Standard
0x01 = 1 dB
0x02 = 2 dB
0x03 = 3 dB
↓
0x04 = 4 dB
0x05 = 5 dB
0x06 = 6 dB Difficult to judge
0dB
(0x00)
---
COM_V34_BIT_RATE_THRESH 310 015
---
0AC
Bit speed selecting threshold value
The smaller value, the easier it is to select higher communication
speed.
0xFA = -8 dB Easy to judge
0xF9 = -7 dB
0xFA = -6 dB
0xFB = -5 dB
0xFC = -4 dB
↑
0xFD = -3 dB
0xFE = -2 dB
0xFF = -1 dB
0x00 = 0 dB Standard
0x01 = 1 dB
0x02 = 2 dB
0x03 = 3 dB
0x04 = 4 dB
↓
0x05 = 5 dB
0x06 = 6 dB
0x06 = 7 dB Difficult to judge
1dB
(0x01)
---
COM_V8_ANSAM_REVERSE 310 016
---
0AD
ANSam signal phase reversing
Set whether perform phase reversing for 450 ms when transmitting
ANSam.
0 = Not perform
1 = Perform
Perform
(1)
---
COM_V8_TE_TIME 310 017
---
0AE
Te time at V.8
When this is set to more than 1 second, echo canceller is disabled.
0 to 25.5 sec (1 step = 100 ms) 1.1 seconds
(11)
---
COM_V34_CC_TIME 310 018
---
0AF
Time-out interval from when starting V.34 mode (Phase 2) to the
control channel.
5 to 255 sec (1 step = 1 sec) 30 seconds
(30)
---
Table 7-19. List of System Parameter (Communication Control)
Label
Maintenanc
e Code
User
Access
Internal
Address
Description Setting Value Default
Remark
s
Main Sub
justmanuals.comjustmanuals.com