Epson AcuLaser CX11 Service Manual

EPSON AcuLaser CX11/CX11F Revision B
APPENDIX Fax Unit System 663
300 011 0x300B
The product received EOR-Q when receiving ECM Line quality is not good Confirm the condition of
the other end machine,
and ask to resend the fax.
*3 Receiving failure 50H: Forced stop Receiving a fax job is
finished
300 012 0x300C
The product terminated the communication by issuing
command reject signal
Not used --- --- --- --- ---
300 013 0x300D
The product terminated the communication by issuing
procedure invalid signal
Not used --- --- --- --- ---
300 014 0x300E
The product terminated the communication because it
received a command reject signal
Not used --- --- --- --- ---
300 015 0x300F
T1 time-out for transmitting a fax The modular cable is
disconnected, or the other
end machine does not
answer
Check that the modular
cable is properly
connected, confirm the
condition of the other
end, and try the failed
operation.
*1, *2 Transmitting failure 50H: Forced stop Transmitting a fax is finished
300 016 0x3010
DCS/NSS resending over The other end machine cut
off the line, or the modular
cable get disconnected
Check that the modular
cable is properly
connected, confirm the
condition of the other
end, and try the failed
operation.
*3 Transmitting failure 50H: Forced stop Transmitting a fax is finished
300 017 0x3011
Fallback error Line quality is not good Try the operation again *3 Transmitting failure
Receiving failure
50H: Forced stop Transmitting a fax is finished
Receiving a fax is finished
300 018 0x3012
Post message resending over The other end machine cut
off the line, or the modular
cable get disconnected
Check that the modular
cable is properly
connected, confirm the
condition of the other
end, and try the failed
operation.
*3 Transmitting failure 50H: Forced stop Transmitting a fax is finished
300 019 0x3013
T2 time-out The other end machine cut
off the line, or the modular
cable get disconnected
Check that the modular
cable is properly
connected, confirm the
condition of the other
end, and try the failed
operation.
*3 Receiving failure 50H: Forced stop Receiving a fax job is
finished
Table 7-23. Operator Call Error
External
error code
Internal
Code
Description Cause Remedies
Panel
Display
(reference)
Report Display
Trigger for
Stopping
Operation
Notification Message
MAIN SUB

Epson AcuLaser CX11 Specifications

General

Brand	Epson
Model	AcuLaser CX11
Category	All in One Printer
Language	English